What to do if coating material drips from the Titan Paint Sprayer nozzle?
Dripping can occur if the air cap, nozzle, or needle is soiled, so clean them. Another cause may be a worn nozzle, which requires changing. Also, the needle may be worn or damaged and need replacement.
Why is there excessive paint mist (overspray) with my Titan Paint Sprayer?
Excessive paint mist can be caused by several factors. If the distance to the object is too large, reduce it. If too much coating material is applied, reduce the volume. If the amount of air is too high, reduce the volume. If the coating substance is over-diluted, reduce the degree of dilution. An incorrect projector set may also be the cause; use a different projector set.
Why is no coating material emerging from the Titan Paint Sprayer nozzle?
Several factors can cause this issue. The nozzle could be clogged and needs cleaning, or the material volume setting might be too low, requiring an increase. Other potential causes include a damaged paint container seal (needs replacement), insufficient pressure build-up in the container (tighten the container), an empty container (refill it), a loose or damaged air tube (insert or replace), a loose feed tube (insert it), a clogged feed tube or filter (clean or replace), a blocked air vent on the feed tube (clean it), or a stuck check valve.
What to do if my Titan Paint Sprayer unit will not start?
First, ensure the unit is receiving power by checking the power source. If the device has overheated, unplug it and allow it to cool down for approximately 30 minutes. Ensure the hose is not bent, the air filter is clean, and the intake slots are not covered to prevent overheating.
Why is my Titan CAPSPRAY X 80 Paint Sprayer atomization too coarse?
Coarse atomization can result from several issues. The material volume might be too high, requiring a reduction. The nozzle could be contaminated and needs cleaning. If the viscosity of the coating material is too high, dilute it further. Insufficient pressure build-up in the container may also be the cause; tighten the container. A heavily soiled air filter should be changed. If the amount of air is too low, increase the volume. Lastly, a damaged air hose should be checked and replaced if necessary.
Why does my Titan Paint Sprayer spray jet pulsate?
A pulsating spray jet can occur if the coating material in the container is running out, so refill it. Another cause may be a heavily soiled air filter, which should be changed. Also, check if the feed tube is loose and insert it, or if the feed tube or filter is clogged, clean or replace them.
How to prevent coating material from causing “paint tears" with my Titan CAPSPRAY X 80 Paint Sprayer?
To prevent paint tears, ensure that you are not applying too much coating material by reducing the volume. Also, increase the distance from the sprayer to the surface. Using a different spray nozzle set may also help.
General| Brand | Titan |
|---|---|
| Model | CAPSPRAY X 80 |
| Category | Paint Sprayer |
| Language | English |
To Next Page