Titan PGD2000 User Manual

9
Refueling
• Always turn the engine off and allow adequate time for it to cool before refueling. ONLY USE
UNLEADED FUEL WITH 86 OCTANE OR HIGHER.
• NEVER refuel your driver with the engine hot, running, or in an unventilated area. Fuel vapors
are extremely flammable and can cause severe injury or death if ignited by a spark or
excessive heat from a hot engine.
• Fill the tank on level ground and avoid spilling the fuel on the motor. Always allow any spilled
fuel to evaporate before restarting the engine.
• Ensure the fuel cap is adequately tightened before restarting the engine.
Installing the Adapter Sleeve
• A 1” adapter sleeve is included with each PGD2000 Post Driver and a 2” adapter sleeve is
included with each PGD3200 Post Driver.
• To install the adapter sleeve, simply press the narrow end of the reducer sleeve into the barrel.
• For ease of inserting/removing, only use half of the rubber pads with your reducer sleeve. For
the most secure fit, use all eight rubber pads with your reducer sleeve.
• Additional sleeve sizes are available for both the PGD2000 and PGD3200 Post Drivers.

Titan PGD2000 Specifications

General

Brand	Titan
Model	PGD2000
Category	Engine
Language	English