5
TT5MTP26-2
Getting Started . . .
>
Keep handles dry, clean and free from oil and grease. Greasy, oily handles are
slippery and may cause loss of control.
>
Do not operate the machine if you are tired or ill, under the inuence of drugs, alcohol
or medication.
>
When the machine is switched off, make sure the cutting attachment has stopped
before setting down the machine.
> Do not operate the engine in a conned space where dangerous carbon monoxide
fumes can collect.
> Operate the machine only in daylight or in good articial light.
> Do not touch any moving parts before they have come to a complete stop.
> Operate the machine in a recommended position and only on a rm, level surface.
> Never operate the machine on a ladder or other insecure support.
> Operate the machine only at reasonable hours – not early in the morning or late at
night when people might be disturbed.
> Make sure that the ventilation openings are kept clear of debris.
> Make sure that the air intake of the combustion engine is clear. Keep the air intake
free of dust, dirt particles, gases and fumes.
> Never use the machine without the air lter installed.
>
Check for signs of wear or damage before each use, after any impact or if the machine
has been dropped. Repair the machine if necessary.
> Stop the engine, disconnect the spark plug connector:
• before clearing blockages;
• before cleaning or servicing the machine;
• after striking a foreign object. Inspect the machine for damage and make repairs
before restarting and operating the machine;
• if the machine starts to vibrate abnormally (check immediately);
• whenever you leave the machine unattended;
• before refuelling.
Additional safety warnings for brush cutter and grass trimmer
> Before starting the engine, make sure the cutting attachment is not contacting any
objects.
>
Thoroughly inspect the area where the machine is to be used and remove all stones,
sticks, wires, bones and other foreign objects.
> Avoid operating the machine in wet grass or take additional precautions to avoid
slipping.
> When operating on a slope, always stand at a lower level than the machine. Never
cut or trim on an icy, slippery hill or slope.
>
Do not operate the cutting attachment when crossing surfaces other than grass, and
when transporting the machine to and from the working area.
> Take care against injury from a cutter tted for trimming the cutting line length. After
extending the cutter line always return the machine to its normal operating position
before switching on.
Safety information
To Next Page
Loading...
Need help?
General
