Why does my Titan Power Tool have excessive vibration and noise?
Excessive vibration, noise, or exhaust from your Titan Power Tool can stem from a few issues. The cutting device might be dull or damaged, in which case you should replace it with a new one. Also, check if any bolts or nuts are loose and tighten them. Finally, incorrect petrol/oil can cause this issue; empty the unused petrol/oil and refill with the correct type.
What to do if my Titan TTK587GDO engine stops?
If your Titan Power Tool engine stops, check two things. First, ensure that there is enough fuel in the fuel tank and add fuel if needed. Second, inspect the cutting device for any blockages and remove them.
Why is the cutting performance of my Titan Power Tool unsatisfactory?
Unsatisfactory cutting performance of your Titan Power Tool can be due to a dull or damaged cutting blade, which should be sharpened or replaced by a specialist. Also, ensure you are only cutting materials according to the product's capacity.
Defines the product's applications and initial safety guidelines.
Steps to assemble the grass trimmer attachment to the main unit.
Details on fuel type, mixing ratio, and filling the tank.
Step-by-step guide for cold and warm engine starts.
Procedures for using the tool and shutting it down safely.
Instructions for lubricating the saw chain and its components.
Explains kickback dangers and methods to avoid them.
Solutions for engine problems and unsatisfactory cutting performance.
General| Model | TTK587GDO |
|---|---|
| Power Source | Corded Electric |
| Chuck Size | 13 mm |
| Drilling Capacity in Wood | 30 mm |
| Drilling Capacity in Steel | 13 mm |
| Cable Length | 2 m |
| Reverse Function | Yes |
| Variable Speed | Yes |
| Type | Hammer Drill |
To Next Page
