Titan Performance Parts 2
Installation Procedure
Step 1
Remove Stock Air Filter
Remove plastic cover and air filter assembly.
Step 2
Install Billet Intake Adapter
Line up the venturi on the back of the Billet Intake
Adapter to match carburetor intake. Place the adapter
on the bolts, slide down and fasten the 2 nuts
Step 3
Install Air Filter
Place the clamp on the filter base. Slip the filter over
the adapter. Tighten the clamp moderately to finger
tight. Install Red Pre-filter (optional)
Step 4
Remove Stock Exhaust
Remove the two nuts just below the stock exhaust.
Remove the stock exhaust.
Step 5
Assemble Header and Silencer
Slide the clamp over the end of the silencer. Slide the
exhaust header into the silencer about 1-1/2 to 2
inches. Tighten the clamp Allen screw.
Step 6
Install Exhaust Assembly
Place the exhaust gasket on the exhaust port. Line up
the exhaust assembly and insert the flange over the
exhaust mounting bolts. Fasten with two nuts. Install
screw in support bracket (use one of the screws
previously removed.
To Next Page
Loading...
