Need help?Do you have a question about the Titus TMR and is the answer not in the manual?
Insert inner cone assembly into outer cone, aligning tangs with receptor slots.
Rotate inner cone 10 degrees for support by receptor slots; spring clips secure tangs.
Adjust 'L' shaped retainer brackets upwards for diffusers 14"-36".
Lock 'L' slide retainers with screws to prevent release of inner cone tangs.
Adjust Type 1 inner cone by repositioning and reinserting screws for fixed positions.
Adjust Type 2 inner cone by sliding cones up/down and tightening screws.
Adjust Type 3 inner cone by rotating the center cone clockwise or counter-clockwise.
To Next Page
General
