EasyManua.ls Logo

TLC DCH-3100P - Page 8

TLC DCH-3100P
22 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ООО «ТЛК Трейд» | 196158, г.Санкт-Петербург, Пулковское шоссе, д.30, корп.4, оф. 213В (юр.) | ИНН 7810592830 КПП 781001001
р/с 40702810068000007550 | к/с 30101810200000000704 | Филиал ОПЕРУ ОАО Банк ВТБ в Санкт-Петербурге | БИК 044030704
ОКПО 66035862 | ОКАТО 40284565000 | ОГРН 1107847196060 | т.(812)6499888 | http://www.tlct.ru http://www.rftel.ru
ООО «ТЛК Трейд», Санкт
-
Петербург
+7 812 64 99 888
mail@tlct.ru
Audio1 Level: modify the audio1 level within this range: 0~99.
Audio1 Mode: select Stereo, Left, Right or Mono for soundtracks.
Audio1 Priority: select the priority of the audio.
Audio2 Level: modify the audio2 level within this range: 0~99.
Audio2 Mode: select Stereo, Left, Right or Mono for soundtracks.
Audio2 Priority: select the priority of the audio.
Audio Config: you can set as Two PID or One PID
HDMI/AES Embeded: select from PCM or Compressed. Select
Compressed to enable HDMI Dolby pass-through. Otherwise select PCM.
Biss
It includes Biss Mode, Biss 1 Setup and Biss E Setup
Biss Mode
Set Biss mode, can select ‘OFF’, ‘Biss E’ or ‘Biss 1’
Biss 1 Setup
set Biss 1 (password is required)
Biss E Setup
set Biss E (ID number and password are required)
A/V Alarm Switch: there are two switches control the alarm separately:
Video Alarm: enable or disable the video alarm.
Audio Alarm: enable or disable the audio alarm.
Local Setup
IP Address: The IP address for the unit.
Network Mask: The network mask for the subnet to which the unit is
connected.
Gateway: The gateway for the network to which this unit is connected.
Trap IP
The DCH-3100P provides a Monitor Center IP address. You can set this to be
the same IP address of the Monitor Center, which is typically a PC in order to
allow the device to send messages to the monitor center.
System
Unit Name
The DCH-3100P allows you to edit the unit name which is displayed on the front
panel LCD. Default name is ‘Digital TV Processor”. The unit name should be
within 20 characters in ASCII format.