TMA | Białostoczek 26,gm.Zabłudów,15-592 Białystok; Poland ; VAT PL5420008413; GIOŚ: E0021166WZ;
Tel. +48 857431246
1. General information
Thank you for your purchase of TMA manufactured UV sterilization product. All the raw
materials and components are of best quality and were processed or manufactured in the EU
countries. Sterilizers made by TMA are made from highest quality stainless steel. The thickness of the
chamber wall guarantees high factor of safety in operation. All of the devices successfully
completed 30 Atm pressure trials.
The innovative design of the TMA sterilizers allows for continuous work of the devices even
without the flow of water through the chamber. The design of the chamber contributes to lower
incidence of sediment from calcium and magnesium on the surface of the quartz sleeve.
In the sterilizers of the V series we introduced additional guides for the quartz sleeves easing
the assembly and disassembly. The solution allows for the same ease of assembly for device working
horizontally, vertically or at any other angle. The guide prevents the quartz sleeve from breaking
during routine maintenance. The turbulent flow induced by the guide increases the efficiency of
disinfection. During the first 100 hours of operation the efficiency of disinfection is greater by 15%
from the rated for the device.
We provide you with devices equipped with a new electronic control panel (in V20LA,
V25LA, V40, V80, V120) that indicates:
Total work time (days),
Remaining time until UV lamp replacement (days),
Number of ON/OFF cycles,
Visual and audible signal 7 days before the required UV lamp replacement,
Visual and audible signal when UV lamp replacement is required,
Visual and audible signal when UV lamp is burnt out.
The detailed instructions of the new panel are provided on the casing of the electrical
enclosure.
Sterilizers of the V series have a steel muff with a hood that functions as a sight glass. This
innovative solution of a light muff allows for optical control of the working condition of the lamp.
We hold high hopes that the implementations of these innovative solutions in the V series
sterilizers fulfill your expectations concerning the effectiveness and operation of our devices.
The device delivered to you shall be protected from severe shocks and drops, as the quartz
sleeve and UV lamps are brittle and fragile. The sterilizer shall be transported exclusively in horizontal
position. The manufacturer is not responsible for damage arising from the conditions of transport.
Before installation and operation one shall read the instructions and implement the
precautions listed. Noncompliance with these precautions is grounds for releasing the manufacturer
from warranty obligations.
The used electrical and electronic equipment with the crossed-out rubbish bin symbol shall be collected
separately. It is prohibited to put the used equipment with other waste. Inadequate use of the used
equipment may have a negative impact on the environment and people's health. Separate collection
of the equipment contributes to its re-use and recycling. The obligation of the used equipment selective
collection rests on the user, who should provide it to the used equipment collector.
TMA devices are equipped with lamps that emit UV radiation, light sources that contain mercury. The
owners of waste lamps containing mercury are obliged to collect them separately for further re-use and
disposal.
To Next Page