Injection Molding Machine Chapter 5
V3.0
5-14
2.3 System Message & Description
01 Power on- system test 31 Transfer to manual operation first!!!
02 Information being transmitted， please wait!
32 No operation until after machine is started!
03 Information being received， please wait! 33 if correction is required， please input new
week!
04 Information transmission---OK--- 34 input pre-heat time: HH:MM
05 Information transmission ---error--- 35 input pre-heat week: 0-6
06 Information receiving---OK--- 36 several buttons shall not be depressed
simultaneously!!
07 Information receiving---error--- 37 alarm condition cut off signal not cleared!!
08 Input---OK--- 38 --- push button being locked ---
09 Input---error--- 41 CPU board J2 being protected
10 Input---machine in operation--- 42 Only EEPROM can be written in
11 Information transmission ---error--- 43 mold adjustment can not be made [I/O
204*255]
12 Alarm!RAM error!
44 information being protected， input code
1!
13 Module memory being written in， please
wait
45 operator parameter being protected!
14 Module memory being read， please wait 46 if screen information is to be printed，
please depress “ENTER” button
15 Module memory transmission completed
47 if printing is to be terminated， please
depress “ENTER” button
16 Information being protected， input code 1!
48 please turn power off and remove memory
card
17 Information being protected， input code 2!
49 insert information card!(INFO)
18 Insert program edit card!(EDIT) 50 ‘BLOCK’ number repeat!!!
19 Insert module memory card!(MOLD) 51 ‘LD?_??’ command too short
20 If correction is required， please input new
date
52 ‘COUNT’ command has no times counting
signal!!!
21 If correction is required， please input new
time
53 ‘BLOCK’ number not appear!!!
22 Code error!! 54 Command code error!!!
23 Information being protected， input code!
77 Printer not connected!!!
24 C.P.U. board write-in being protected 78 Information being printed!!!
26 Memory card category is being
reset...please wait!!!
27 Machine in operation! not to operate this
button!!!
28 Program being edited! no operation shall be
made!!!
29 This module code can not be written in!!!
30 This module code can not be read out!!!
To Next Page
Loading...