TMC 30E - Page 41

Injection Molding Machine Chapter 4
V3.0
4-0
Chapter 4: Operation
1. Operation panel……………………. 4-1 4. Strat up……………………………… 4-55
1.1 Screen/Function selection key.. 4-1 4.1 Manual operation........................ 4-55
1.2 Number/Alphabet key………… 4-1 4.2 Semi-automatic operation .......... 4-56
1.3 Direction/Screen operation
instruction key…………………. 4-1
4.3 Fully automatic operation ........... 4-57
1.4 Manual operation switch….….. 4-1 4.4 Emergency stop ......................... 4-57
4.5 Alarm clearance ......................... 4-57
2. Screen layout and operation……… 4-3 4.6 Re-start after safety devices
were tripped……………………… 4-58
2.0 Main page of operation screen 4-5 5. . Molding operation……………………. 4-58
2.1 Main menu……………………… 4-7 5.1 Preparation before operation...... 4-58
2.2 Machine monitoring screen 4-8 5.2 Check before operation.............. 4-58
2.3 Clamp open /close setting........ 4-9 5.3 Molding condition setting............ 4-59
2.4 Clamping parameters............... 4-11 5.4 Start molding.............................. 4-60
2.5 Ejector setting .......................... 4-13 5.5 Change material or color change 4-60
2.6 Ejector parameters................... 4-15 5.6 Store/read molding condition by
memory card…………………….. 4-60
2.7 Corepull setting ........................ 4-17
2.8 Core parameters ...................... 4-19 6. Machine shutdown procedures 4-61
2.9 Injection setting ........................ 4-20
2.10 Injection parameters............... 4-22
2.11 Injection closed loop control... 4-24
2.12 Charge/Carriage setting......... 4-26
2.13 Charge/Carriage parameters.. 4-28
2.14 Temperature setting............... 4-30
2.15 Temperature parameters ....... 4-31
2.16 Molding data store.................. 4-33
2.17 SPC data................................ 4-34
2.18 Function setting/Pressure
testing ....................................
4-36
2.19 Production management........ 4-38
2.20 Automatic mold adjustment.... 4-39
2.21 Automatic purge function ....... 4-41
2.22 External I/O monitor ............... 4-42
2.23 Change record ...................... 4-46
2.24 Alarm record…………..……... 4-47
2.25 Maintenance check point ....... 4-48
2.26 Molding support...................... 4-50
2.27 System self diagnostic ......... 4-51
2.28 Internal I/O monitor…….…… 4-52
2.29 T/C setting…………………… 4-53
2.30 Screen print…………………. 4-54
3. Machine operation procedures…… 4-55