Injection Molding Machine Chapter 4
V3.0
4-25
Ａ Injection function ON：injection speed will be immediate feedback to perform closed loop
control.
Ｂ Pressure holding function ON：holding pressure will be immediate feedback to perform
closed loop control.
Ｃ Y coordinate on the left is the pressure.
Ｄ Y coordinate on the right is the speed.
Ｅ X coordinate is the time or position. To the left ▲ X coordinate is time，to the right，X
coordinate is position，when X-TIME is on，the X coordinate is changed to time scale.
Ｆ X-TIME：When set on，unit of x-axis is changed to time scale.
To Next Page
Loading...