7
Please note: The magnet brackets used on the Reef Flow 2.0 nano are extremely strong
and the force with which they attract each other could cause serious injury if the magnets
are not handled correctly. Therefore please read and take note of the following guidelines:
Caution: Never place your fingers or any other body part between the two halves of the
magnet.
Caution: Always slide magnets together and apart - do not allow magnets to slam
together as this could damage the magnets, the aquarium glass, and/or cause the
magnets to chip or shatter with a possible risk of injury to the user.
4. Secure the pump by gently sliding the magnet on the outside of the aquarium into the
correct position.
Please note: suitable for a maximum glass thickness of 15mm.
5. Secure the controller near the aquarium,(ensuring a drip loop is in place) in a dry and
non humid area (ideally on the outside of the cabinet - do not place the controller in the
cabinet with a sump as this may be too humid). Connect the controller DC plug to the
pump DC connector.
6. With the mains power switched off, connect the PSU DC plug to the controller DC input.
7. Ensuring that the pump is fully submerged and all connections are made, switch the
power on at the mains. The pump will enter its last used settings.
PUMP OPERATION
The pump has several functions to control output and wave type.
We advise you to speak with your local fish shop to determine which settings will be best for
the species of corals and the aquarium size you own.
A little experimentation is often required to achieve the best results, as no two setups or
scapes are the same.
To Next Page
Loading...
Need help?
General
