To Next Page

To Previous Page

Red LED = Continuous Stream mode

Press the intensity button to increase/decrease the power

intensity of the pump

Orange LED = Reef mode

Press the intensity button to increase/decrease the frequency

between each Reef wave.

Green LED = Pulse mode

Press the intensity button to increase/decrease the frequency

of each Pulse wave.

OPERATION OF THE DC CONTROLLER

Press the Mode button to cycle the Reef Flow 2.0 nano through the following:

Green LED Flashing = Feed mode

Press and hold the mode button for approximately 2 seconds to enter Feed mode

to pause pump operation for 10 minutes. The controller will then start a 10 minute

countdown. When the 10 minutes have elapsed the pump will resume operation and

start pumping.

If you wish to restart the pump before the end of the 10 minute pause, press the mode

button again and the controller will display a RED ﬂashing LED to indicate it is off and

then press the mode again and the pump will restart.

Red LED Flashing = OFF

Please note: When making any changes to the Wave Mode settings it is important that

you check and observe the effect any change made will have on your individual aquarium

and make sure that the wave intensity and frequency is suitable for your size aquarium and

its inhabitants.

Please note: In the event of a power cut, your Wave Mode settings will be saved.

Questions and Answers:

Need help?

Do you have a question about the TMC Reef Flow 2.0 1000nano and is the answer not in the manual?

TMC Reef Flow 2.0 1000nano Specifications

General