TNI softFlow 50 Instructions For Use

Other manuals for TNI softFlow 50

Operating Instruction56 pages

Operating Instructions36 pages

• S

  Stacy BowmanSep 7, 2025

  What to do if TNI softFlow 50 displays 'Applicator type'?

  

  Same questionReply

  • M

    mwalterSep 7, 2025

    If your TNI Medical Equipment indicates 'Applicator type', reduce the flow rate or use a larger applicator.

    

    Reply
• E

  Emily BarnettAug 23, 2025

  What to do if TNI softFlow 50 Medical Equipment says 'Please refill water'?

  

  Same questionReply

  • J

    jennifermillerAug 25, 2025

    If your TNI Medical Equipment indicates that you need to refill water, please refill the humidification chamber with water.

    

    Reply
• C

  Christina MartinezAug 25, 2025

  What to do if the flow rate is not reachable on TNI softFlow 50?

  

  Same questionReply

  • M

    Michelle ThomasAug 26, 2025

    If the flow rate is not reachable on your TNI Medical Equipment, ensure you check the air flow and the type of applicator being used.

    

    Reply
• J

  Jennifer LozanoAug 27, 2025

  What to do if the pressure is too high in TNI Medical Equipment?

  

  Same questionReply

  • L

    Lindsay VasquezAug 27, 2025

    If the pressure is too high on your TNI Medical Equipment, you should check the air flow.

    

    Reply
• T

  Todd RyanAug 27, 2025

  What to do if the flowrate is too high on TNI Medical Equipment?

  

  Same questionReply

  • H

    howardrobertoAug 27, 2025

    If the flowrate is too high on your TNI Medical Equipment, check the air flow.

    

    Reply
• L

  Lisa ChurchAug 29, 2025

  What to do if TNI softFlow 50 displays 'Change dust filter'?

  

  Same questionReply

  • A

    abrownAug 29, 2025

    If you receive a message to change the dust filter on your TNI Medical Equipment, you should change the dust filter.

    

    Reply
• W

  wallenSep 13, 2025

  What to do if TNI Medical Equipment shows SD card or file defective?

  

  Same questionReply

  • M

    Mrs. Julie DrakeSep 13, 2025

    If your TNI Medical Equipment displays an error indicating that the SD card or file is defective due to an SD card checksum error, replace the SD card and restart the system. If the error continues, contact your TNI medical AG representative.

    

    Reply
• R

  Robert GoodmanSep 14, 2025

  What to do if TNI Medical Equipment shows applicator not found?

  

  Same questionReply

  • O

    Oscar LopezSep 15, 2025

    If your TNI Medical Equipment displays that the applicator cannot be detected, replace it with a new applicator.

    

    Reply
• A

  Alicia DickersonSep 5, 2025

  What to do if the blower gets too hot in TNI softFlow 50 Medical Equipment?

  

  Same questionReply

  • J

    Joann JenkinsSep 5, 2025

    If the blower gets too hot on your TNI Medical Equipment, refer to the product specifications and check the air flow.

    

    Reply
• J

  James MccarthySep 3, 2025

  What to do if TNI softFlow 50 displays 'Applicator not found'?

  

  Same questionReply

  • X

    xgriffinSep 3, 2025

    If your TNI Medical Equipment says that the applicator is not found, please replace it with a new applicator.

    

    Reply

TNI softFlow 50 Specifications

General

FiO2	21 - 100 %
Patient Population	Adult, Pediatric
Operating Modes	Continuous
Humidity Range	10-95% non-condensing
Power Supply	AC 100-240V, 50/60Hz