What to do if TNI Medical Equipment font could not be loaded?
If your TNI Medical Equipment displays that the font of the selected language cannot be loaded because the file is defective or missing, select the standard font (e.g., English) and contact your TNI medical AG representative for further help.
What to do if TNI softFlow 50 Medical Equipment says 'Please refill water'?
If your TNI Medical Equipment indicates that you need to refill water, please refill the humidification chamber with water.
What to do if the flow rate is not reachable on TNI softFlow 50?
If the flow rate is not reachable on your TNI Medical Equipment, ensure you check the air flow and the type of applicator being used.
What to do if the pressure is too high in TNI Medical Equipment?
If the pressure is too high on your TNI Medical Equipment, you should check the air flow.
What to do if the flowrate is too high on TNI Medical Equipment?
If the flowrate is too high on your TNI Medical Equipment, check the air flow.
What to do if TNI Medical Equipment shows applicator heating defective?
If your TNI Medical Equipment displays that the applicator heating is defective, replace it with a new applicator.
What to do if TNI Medical Equipment shows SD card or file defective?
If your TNI Medical Equipment displays an error indicating that the SD card or file is defective due to an SD card checksum error, replace the SD card and restart the system. If the error continues, contact your TNI medical AG representative.
What to do if TNI Medical Equipment shows applicator not found?
If your TNI Medical Equipment displays that the applicator cannot be detected, replace it with a new applicator.
What to do if the blower gets too hot in TNI softFlow 50 Medical Equipment?
If the blower gets too hot on your TNI Medical Equipment, refer to the product specifications and check the air flow.
What to do if TNI softFlow 50 displays 'Applicator not found'?
If your TNI Medical Equipment says that the applicator is not found, please replace it with a new applicator.
General| FiO2 | 21 - 100 % |
|---|---|
| Patient Population | Adult, Pediatric |
| Operating Modes | Continuous |
| Humidity Range | 10-95% non-condensing |
| Power Supply | AC 100-240V, 50/60Hz |
To Next Page
