TNI softFlow 50 - Choosing the Applicator; Starting Therapy

24
Operating Instruction TNI soft Flow 50 homecare system
3.5) Choosing the applicator
Choosing the applicator
• The TNI soft
Flow 50 supports you by means of an integrated recognition technique.
• Additionally, automatically predened ow rate limits are considered.
TNI soft
Flow 50canbeusedwithalargerangeofapplicators.
Applicator Size Recommended max. ow rate
in l/min.
Note
Small 20 Seriesproductioncomponent
Standard 25 Seriesproductioncomponent
Medium(Specialproduction) 25 Specialproductioncomponent
(limitedavailability)
Large 50 Seriesproductioncomponent)
Xlarge(Specialproduction) 50 Specialproductioncomponent(limitedavailability)
Applicator-Family Available series production
components
Description
Applicatorclinic small/standard/large max.366therapyhours,singlepatientuse
Applicatorhomecare small/standard/large max.720therapyhours,singlepatientuse
3.6) Starting therapy
WARNING
• Before starting a therapy, please make sure that all components are inserted and /or
connected correctly (see chapter 3).
• Before switching on the device, make sure that the water container is lled up with water!
Startingtherapy
• Setthemainpowerswitchtoposition„I“.
• Thedeviceswitchesonshowingforapprox.5seconds
 o thermware-Statusand
 o theselectedhumidiertype
• andbeginstooperate.
• Aftertherstapplicationthesystemstartswiththepreviouslysetvalues.
• Ifnecessary,applytherequiredquantityoxygentotheTNI soft
Flow 50.
Ifthedeviceisinthestandbymode:

•  Thesystemswitcheson.
•  Bypressingthefunctionkeys,thedisplayilluminationisactivatedintheoperationmode.
• Ifnecessary,applytherequiredquantityoxygentotheTNI soft
Flow 50.
•  Thedisplayshowstheoperationmodeandthecurrentparameter:
 o TheHumidity,dewpointin°DP
 o Theappliedowrateinl/min