TNI softFlow 50 - Stopping Oxygen Supply

26
Operating Instruction TNI soft Flow 50 homecare system
  
• Thesystemgoesintooperationandsuppliestherequiredowrateattheapplicator,theair
owisperceptible,thevalueisobviousinthedisplay.
• SupplytheTNI soft
Flow 50withtherequiredoxygen,adjustthevalue.
• Theoxygenappliedisshowninthedisplayinl/min.
• Thesystemmixestheadjustedair-owratewiththeoxygen.
• Theowrateisreferredtoastotalow;i.e.theair-oxygenmixtureissettotheowrate
speciedinthenominalvalue.
• Therealvalueandtheoxygenconcentration,resultingfromit,FiO
2
in%,isshowninthe
display.
3.9) Stopping oxygen supply
SAFETY NOTE
• The connection to the oxygen source needs to be set up correctly as described in chapter
3.1.7.
• The oxygen supply may only be released with the TNI soft
Flow 50 running.
• Do not supply the TNI soft
Flow 50 with oxygen during standby-mode!
• Please note chapter 3.1.7.
• Thesystemstillsuppliestherequiredowrateattheapplicator,theairowisperceptible.
• TherealowrateandtheFiO
2
,resultingfromit,isshowninthedisplay.
• Switchotheoxygensupplyattheoxygensource.
• Theoxygenshowninthedisplayrisesto0l/min.
• TheFiO2valueshowninthedisplayindicates21%.

 
• Thesystemswitchesoff.
• The
TNI soft Flow 50 nowindicatesthestandbydisplay.