Toa NX-100 Operation Manual

5
Step 3. Press the Start button.
Connection to the pressed Selection button's programmed NX-100 and NX-100S units begins.
If all units are connected, the indication "Connection succeed to all designated units.*" is displayed in
the message display area, and the corresponding Selection button changes color to orange.
* When only a portion of the programmed units is connected, the indication "Connection failure to
some designed units." is displayed.
NX-100 and NX-100S units that are not connected are displayed in the message display area.
Depending on the displayed messages, perform operation again after temporarily terminating the
program and waiting a short time, or after correcting any setting- or unit-related problems. The
Selection buttons change to orange if a connection is made to at least one of the NX-100 or NX-100S
units programmed for that button.
Step 4. Broadcasting can begin when the "Connection succeed to all designated units." indication is
displayed.
Step 5. Press the End button after the broadcast is completed.
Step 6. Select [File] → [Exit] to quit the NX-100 Operation program.

Toa NX-100 Specifications

General

Brand	Toa
Model	NX-100
Category	Adapter
Language	English