3
When Installing the Unit
• (Applicable to VX-2000DS and VX-200PS only)
Never plug in nor remove the power supply plug with wet hands, as doing so may cause electric shock.
• (Applicable to VX-2000DS and VX-200PS only)
When unplugging the power supply cord, be sure to grasp the power supply plug; never pull on the cord
itself. Operating the unit with a damaged power supply cord may cause a fire or electric shock.
• (Applicable to VX-2000DS, VX-200PS, VP-2064, VP-2122, VP-2241, and VP-2421 only)
Do not block the ventilation slots in the unit's cover. Doing so may cause heat to build up inside the unit and
result in fire.
•
Avoid installing the unit in humid or dusty locations, in locations exposed to the direct sunlight, near the heaters,
or in locations generating sooty smoke or steam as doing otherwise may result in fire or electric shock.
• Note correct polarity (positive and negative orientation) when connecting the power supply cord. Reversed
polarity connections will cause damage to the amplifier.
• System units (except remote microphones) are designed exclusively to be mounted in an equipment rack.
Be sure to observe the following instructions when rack-mounting the unit. Failure to do so may cause a fire
or personal injury.
· Install the equipment rack on a stable, hard floor. Fix it with anchor bolts or take other arrangements to
prevent it from falling down.
· When connecting the power cord of the DC power supply panel for the units to an AC outlet, ensure that
the total load current never exceeds the AC outlet's allowable current capacity.
· The supplied rack-mounting screws can be used for the TOA equipment rack only. Do not use them for
other racks.
• (Applicable to VX-2000DS only)
Note correct polarity (positive and negative orientation) when connecting the power supply cord. Reversed
polarity connections will cause damage to the system.
When the Unit is in Use
• (Applicable to VP-2064, VP-2122, VP-2241, and VP-2421 only)
Do not operate the unit for an extended period of time with the sound distorting. This is an indication of a
malfunction, which in turn can cause heat to generate and result in a fire.
• Use the specified power supply unit for the system. Note that the use of other power supply unit may cause
a fire.
• (Applicable to VX-2000DS only)
Make sure to observe the following handling precautions so that a fire or personal injury does not result from
leakage or explosion of the battery.
· Do not short, disassemble, heat nor put the battery into a fire.
· Avoid using both new and old batteries together.
· Never charge batteries of the type which are not rechargeable.
· Do not solder a battery directly.
· Be sure to use the specified type of batteries.
· Note correct polarity (positive and negative orientation) when connecting a battery to the unit.
· Avoid locations exposed to the direct sunlight, high temperature and high humidity when storing batteries.
• (Applicable to RM-200SF and RM-200SA only)
Have the unit checked periodically by the shop from where it was purchased. Failure to do so may result in
corrosion or damage to the unit or its mounting bracket that could cause the unit to fall, possibly causing
personal injury.
• (Applicable to VX-200PS only)
Contact your TOA dealer as to the cleaning. If dust is allowed to accumulate in the unit over a long period of
time, a fire or damage to the unit may result.
Indicates a potentially hazardous situation which, if mishandled, could
result in moderate or minor personal injury, and/or property damage.
CAUTION
To Next Page
Loading...
