Toast Flex 22" Stand Kit
Easy Install Guide
Pro tip: Clear your install area of any obstructions before you get started.
1x Stand
What’s in the box
Plug in your cables. Plug in the USB-C power
and the (optional) ethernet cable in the le
pocket as shown
Remove back panels. Open and remove the
back panel from the top cut outs to expose
the back pockets
1 4
2 5
3 6
1. Power & ethernet cables
2. Grommet to seal the pocket
3. Pocket for cable management
4. Accessory pocket
5. Grommet to set the cable
6. Pocket for cable management
Connect to power and ethernet according to the labels on the back of your Toast Flex 22”
terminal.
Step 1
Follow the step-by-step instructions on the reverse page. 1
4x Thumbscrews
found in the general toolkit
Tools Needed
To Next Page
Need help?
General
