COUNTERTOP FRYERS
e. Check that all connections are tight.
f. Reassemble fry kettle and turn the circuit breaker ON.
3. Installation Check.
a. Place disconnect switch in “On” position, energizing the fry kettle. Turn thermostat dial to 250°F (121.1 °C)
for five seconds; return to “Off” position.
b. Let a few drops of water or solid shortening fall on heating elements to make sure they are heating.
CAUTION:
Do not touch heating elements.
c. Shortening container and heating elements must be thoroughly cleaned before placing the fryer in
operation and cooking. Refer to Cleaning in the Operation Section.
SECTION 2 - INSTALLATION
12
Toastmaster
®
To Next Page
Loading...
