4
This is normal and should quickly disappear. It will not recur after appliance has been
used a few more times.
BEFORE USING
Solid surface countertops can be easily scratched, cracked, scorched, or damaged,
especially when exposed to heat. To prevent damage, the following precautions should
be observed when using this product:
• Always use a trivet under heat generating sources such as Slow Cookers, Toaster
Ovens, Skillets, Deep Fryers, etc.
Carefully unpack the deep fryer and all parts. Remove all packaging materials, including
any stickers or labels. Clean the interior and exterior surfaces of the deep fryer with
a damp cloth or sponge. Wipe dry with a soft cloth. NEVER IMMERSE THE DEEP
FRYER OR CORD IN WATER OR ANY OTHER LIQUID. Position the deep fryer on
a dry, level, heat-resistant surface. It is recommended to operate this appliance on a
separate outlet and circuit from other appliances to avoid overloading the circuit.
Use only the magnetic cord set provided with this product. The use of any other magnetic
cord set may cause re, electric shock, or injury.
Attach the power cord to the unit by aligning the magnetic plug end of the cord assembly
with the two electrical pins located in the recessed area of the base. When properly
aligned, the plug will magnetically attach itself to the appliance. For proper connection,
the magnetic plug end must be parallel with the countertop.
Important: The magnetic cord was designed to detach easily from the deep fryer. As a
result, if it is bumped or touched during use it could possibly detach causing the unit to
stop heating. Avoid contact with cord during operation. If contact occurs, verify that the
cord is still properly connected.
USING YOUR DEEP FRYER
1. Place your deep fryer on a clean, dry, level, stable, and heat-resistant surface in
center of the countertop.
2. Fill unit with cooking oil to the oil ll line, which is located on the inside of the unit.
NEVER ll the deep fryer past the MAX ll line. Be sure the oil level is between the
minimum and maximum levels. NEVER RUN THE DEEP FRYER WITHOUT OIL.
3. Attach the magnetic cord according to instructions on page 4.
4. Plug cord into a 120 volt wall outlet.
5. Adjust the temperature control to the desired or required temperature. NOTE: The
oil may be heated with or without the deep fryer lid in the closed position. If the lid
is in the closed position, it will prevent possible splattering.
6. When oil reaches desired temperature, the ready light will illuminate.
7. Place food in the basket. Then slowly lower the basket into the oil in the fryer base.
DO NOT overload the basket as this will substantially lower the oil temperature and
the food will absorb more oil. Also, overloading can cause a boil over. Please note
that high moisture foods can cause a boil over. Take caution when lowering the
basket to make sure it does not boil over.
8. Lower the fryer lid into the closed position to prevent splatter.
9. When food is placed in the deep fryer, it will naturally cool the oil thereby making the
ready light turn off. This is normal.
To Next Page
Loading...
