INSTALLATION24
5
z Do not charge the battery when the elec-
trolyte level is low. Otherwise, the bat-
tery will be damaged and may cause
malfunction.
ENOW00014-0
z Make sure that the battery leads do not
get stuck between the outboard motor
and boat when turning, etc.
z The starter motor may fail to operate if
the leads are incorrectly connected.
z Be sure to correctly connect the (+) and
(—) leads. If not, the charging system will
be damaged.
z Do not disconnect the battery leads from
battery while the engine is operating, the
electrical parts could be damaged.
z Always use a fully charged battery.
ENOW00015-0
Do not use a battery that is not recom-
mended. Use of a battery not recommended
can lead to poor performance of, and/or
damage to, the electrical system.
ENON00006-A
Note
Recommended battery: 12V 40Ah/5HR,
350 (Cold Cranking Amps (CCA), In case of
cold whether: 12V70Ah/5HR (650CCA))
Specifications and features of batteries
vary among the manufacturers. Consult
the manufacturer for details.
* The battery should be purchased sepa-
rately and is not supplied with the out-
board motor.
1. Place the battery box in a convenient
position away from possible water
spray. Securely fasten both the box
and the battery so they do not shake
loose.
2. Connect the positive lead (+) to the
positive terminal (+) of the battery,
and then connect the negative lead
(—). When disconnecting the battery
always remove the negative lead (—)
first. After connecting the positive
terminal (+), securely place a cap on it
to prevent short circuits.
1. Battery cord (red)
2. Battery cord (black)
CAUTION
CAUTION
To Next Page
Loading...
