REMOVING AND CARRYING THE OUTBOARD MOTOR52
8
ENOW00071-0
The tilt support device supplied on your out-
board motor is not intended for towing. It is
intended to support the outboard motor
while the boat is docked, beached, etc.
When transporting a boat on a trailer
with the outboard motor still attached,
disconnect the fuel line from the out-
board motor beforehand and keep the
outboard motor in the normal running
position or on a transom saver bar.
Tiller handle type
To prevent the outboard motor from
moving when it is attached on a boat
during transport on a trailer, properly
tighten the steering friction lever
(page 53).
1. Ground clearance should be provided
sufficiently.
2. Transom saver bar
ENOW00067-0
Do not go under outboard motor tilted up
even if it is supported by support bar, or
accidental fall of outboard motor could lead
to severe personal injury.
CAUTION
WARNING
To Next Page
Loading...
