INSPECTION AND MAINTENANCE 73
10
ENOW00066-0
Do not carry or store outboard motor in any
of positions described below.
Otherwise, engine damage or property dam-
age could result from leaking oil.
ENON00021-1
Note
z If the outboard motor must be laid
down be sure drain the fuel, then the
outboard motor on a cushion as shown
in the following drawing (See page 73
and page 51).
z Elevate power unit 2 inches to 4 inches
if traveling to avoid oil spillage.
ENOM00950-0
Adding a fuel stabilizer
When adding a fuel stabilizer additive
(commercially available), first fill the fuel
tank with fresh fuel. If the fuel tank is only
partially filled, air in the tank can cause
the fuel to deteriorate during storage.
1. Before adding fuel stabilizer additive,
drain the vapor separator (See
page 73).
2. Follow the instructions on the label
when adding the fuel stabilizer addi-
tive.
3. After adding the additive, let the out-
board motor run in the water for 10
minutes to make sure any old fuel in
the fuel system has been completely
replaced by the fuel with additive.
4. Turn the engine OFF
ENON00891-0
Note
If your motor is used occasionally, it is rec-
ommended to use a good fuel stabilizer in
every tank of fuel and keep the container
full to reduce condensation and evapora-
tion.
ENOM00970-E
Fuel system draining
ENOW00936-0
For details on handling fuel, contact an
authorized dealer.
Fuel and fuel vapors are extremely flamma-
ble and can be explosive.
z If fuel is spilled, wipe it up immediately.
z Keep the fuel tank well away from sources
of ignition, e.g. sparks or open flames
z Perform all work outdoors or in a well
ventilated place.
ENOW00097-0
Be sure to use cloth to remove fuel remain-
ing in the cowl and dispose of it in accor-
dance with local fire prevention and
environment protection regulations.
CAUTION
ENOF01219-1
ENOF01221-1
WARNING
WARNING
To Next Page
Loading...
Need help?
General
