8
Assembling the Overhead Beater cont’d
The beater will sit in the beater mounts, which
are on the front uprights and look like a ridged
block. Aer the shas have been hung, you can
li the beater up and drop it into the beater
mount. Experiment with which posion in the
ridges is best for your arm length and shed size.
Mounng the control box on the rails
This is best with 2 people as you will need to balance the box on
the rails while aaching it. Start by placing the 2 rails on a at
surface and hold them steady while placing the box carefully on
top. The front rail and the front of the box have the Toika logo
on them.
Remove the lid by loosening the 2 screws at each end of the box. The screws will stay axed to the lid. Li
the lid and set aside
Line up the holes in the 4 corners of the box with the holes in the rails. Screw rmly in place.
To Next Page
Loading...