Toku TNB-16K/110 - User Manual

Unsafe use of this machine may cause serious injury of death.
Operators and maintenance personnel must read this manual
before operating or maintaining this machine. This manual should
be kept near the machine for reference and periodically reviewed
by all personnel who will come into contact with it.
Hydraulic Breaker
TNB-08M
TNB-6M
TNB-27K/190LU2
TNB-1M
TNB-6E
TNB-230LU2
TNB-2M
TNB-7J
TNB-310LU1
TNB-3MB
TNB-16K/110
TNB-60K/400LU2
TNB-4M
TNB-141LU
TNB-5M
TNB-151LU2
M A N U A L
INSTRUCTION MANUAL
TOKU PNEUMATIC CO., LTD.
No.17
WARNING

Summary

INTRODUCTION

0-1. SAFETY INFORMATION

Explains safety messages and labels for understanding hazards.

SAFETY

1-1. GENERAL PRECAUTIONS FOR SAFETY

Outlines essential safety rules and requirements for breaker operation.

1-2. SAFETY OPERATION

Provides guidelines for safe operation at the worksite and jobsite.

1-3. PRECAUTION FOR MAINTENANCE

Details crucial precautions to take before and during maintenance.

1-4. PRECAUTIONS FOR LIFTING THE HYDRAULIC BREAKER

Specifies safety measures and procedures for lifting the hydraulic breaker.

OPERATION

2-1. SPECIFICATIONS

2-2. PRINCIPLE OPERATION

2-6. INSTALLATION OF THE HYDRAULIC BREAKER ONTO THE EXCAVATOR

2-7. INSTALLATION OF CHISEL

Details the procedure for installing the chisel into the breaker.

2-8. REPLACEMENT OF CHISEL

Explains how to replace the chisel, with variations for different bracket types.

2-9. LUBRICATION OF CHISEL

2-10. INSPECTION PRIOR TO OPERATION

2-11. TEST RUN

2-12. OPERATION OF HYDRAULIC BREAKER

2-13. PRECAUTIONS DURING OPERATION

2-14. DISMANTLING THE BREAKER

MAINTENANCE AND INSPECTION

3-1. DAILY CHECK (pre-start inspection) · PERIODIC INSPECTION

Covers daily checks and periodic inspections of key breaker components.

3-2. INSPECTION FOR LOOSENESS AND RETIGHTENING OF BOLTS AND NUTS

3-3. INSPECTION OF RETAINER PINS

3-4. INSPECTION OF CHISEL BUSHING WEAR

3-5. INSPECTION OF CHISEL WEAR

3-6. INSPECTION OF CHISEL HOLDER BUSHING WEAR

3-7. INSPECTION OF NITROGEN GAS PRESSURE AND RECHARGE

Covers checking and recharging nitrogen gas pressure for optimal performance.

3-9. REPLACEMENT OF OIL FILTER ELEMENT

3-10. CHANGE THE HYDRAULIC OIL IN THE TANK

TROUBLE SHOOTING GUIDE

5-1. OIL LEAKAGE

Identifies causes and countermeasures for oil leakage at various points on the breaker.

5-2. NITROGEN GAS LEAKAGE

Addresses causes and solutions for nitrogen gas leakage from the breaker's cylinder.

5-3. POOR OPERATION OF BREAKER

Lists common operating issues and their corresponding solutions.

Toku TNB-16K/110 Specifications

General

Brand	Toku
Model	TNB-16K/110
Category	Power Tool
Language	English