3. LUBRICATION: a. Change engine oil. b. Clean out area around spark plug. Remove spark plug and
pour one tablespoon of engine oil into cylinder through spark plug hole. c. Replace spark plug, but leave
spark plug cap disconnected. d. Pull Starter Handle to distribute oil in cylinder. Stop aer one or two
revolutions when you feel the piston start the compression stroke (when you start to feel resistance).
4. STORAGE AREA:
Cover and store in a dry, level, well-ventilated area out of reach of children. Storage area should also be
away from ignition sources, such as water heaters, clothes dryers, and furnaces.
NOTICE: During extended storage periods the Engine must be started every 3 months and allowed to run
for 15 – 20 minutes or the Warranty is VOID.
5. AFTER STORAGE:
Before starting the Engine during or aer storage, keep in mind that untreated gasoline will deteriorate
quickly. Drain the fuel tank and change to fresh fuel if untreated gasoline has been sitting for a month, if
treated gasoline has been sitting beyond the fuel stabilizer’s recommended time period, or if the Engine
does not start.
OPERATING INSTRUCTIONS
16
To Next Page
Loading...
