or not. During cutting, THC needs to work on Auto Mode and it should be controlled by CNC, having
nothing to do with this Auto button
Height
It is used to adjust cutting torch height during Auto Mode. Height increases when it is turned
clockwise. At the first commissioning, turn clockwise maximum to reach the highest height.
Sensitive
On Auto Mode, the Sensitive increases when it is turned clockwise.
Sensor ring Port
One end of HF Cable link with the socket, the other end link with the sensor ring groupware
As figure 3-2 shows，CHC-200F has only two connectors for installation, one is to CNC（X1-
CNC）, the other one is to lifter motor (X2-TORCH).
To CNC controller
GND
To lifter motor
and limit switch
Figure 3-2
To Next Page
Loading...