Need help?Do you have a question about the TOMATECH CHC-200F and is the answer not in the manual?
General| Dimensions | Unknown |
|---|---|
| Temperature Range | 0 ~ 50℃ |
| Input Sensor | Thermocouple: K, J, R, S, B, E, T, N, W5Re/W26Re; RTD: Pt100Ω, JPt100Ω; Analog: 0~10V, 0~5V, 1~5V, 0~20mA, 4~20mA |
| Output | Relay, SSR drive, Current |
| Control Method | ON/OFF control, PID control |
| Power Supply | 100~240VAC 50/60Hz |
| Display | PV: 4-digit 7 segment LED, SV: 4-digit 7 segment LED |
| Accuracy | ±0.3%FS |
| Sampling Time | 500ms |
| Mounting | Panel mounting |
| Frequency | 50/60Hz |
| Operating Temperature | 0 ~ 50℃ |
| Protection | IP65 (Front panel) |
| Cooling Method | Self-cooling |
| Weight | About 140g |
Details the technical specifications of the CHC-200F, including power, output, and operating parameters.
Highlights the new functionalities and improvements in the CHC-200F compared to previous models.
Explains the operational principles and components of the CHC-200F's control system.
Lists and illustrates the components included for the CHC-200F flame cutting system.
Introduction to the operation panel, including indicators and buttons.
Details the connectors used for installation and connection of the CHC-200F.
Defines the pin assignments and specifications for the 7-pin socket connecting to the CNC.
Defines the pin assignments and specifications for the 5-pin socket connecting to the torch lifter motor.
Guides on physically setting up the CHC-200F and its sensor ring.
Details the procedure for testing and configuring the CHC-200F after installation, including indicator checks.
Details the commissioning and adjustments for the THC driver circuit board.
To Next Page