1.Always connect the charger to a GROUNDED outlet. When using
an extension cord, avoid excessive voltage drops by using a
grounded, 3-wire, 12-AWG cord no longer than 30 feet (10m).
CHARGE COMPLETE: the LED light is green,
CHARGE STATUS: the LED light is amber,
it means in absorbtion phase .
FAULT: the LED light is red and flashing,
it means charge error.Reset charge power and
refer to Troubeshooting below.
it means absorbtion phase complete or charger
in Maintenance Mode.
2. Never connect a charger to the same outlet as any
other device. Recommended circuits are 30 amps.
To Next Page
Loading...
