Headrest
Holding the release button on the side of the opening in the top of the
seat, slide the metal rods into the openings on the top of the driver’s
and passenger’s seats. Be sure that both metal pieces slide into the
holes on the tops of the seats and the headrest is facing the correct
position. NOTE: Be sure to hold the release button on the top of
each seat while inserting the headrest into their appropriate locations.
WARNING: Before attempting to operate this vehicle, be sure to
tighten all loose bolt connections. Do NOT attempt to operate this
vehicle with hand-tightened, or loose bolt connections.
19
To Next Page
Loading...
