Tomberlin VANISH - PRE-OPERATING INSPECTION

VANISH Operator’s Manual Page 75
PRE-OPERATING INSPECTION
Before the VANISH is driven you must always perform a Pre-
operation inspection.
Each vehicle has been thoroughly inspected by both the
manufacturer and dealer. Before the initial operation, it is
important that the user inspect the vehicle using the following
guidelines:
General: all parts are securely fastened to the vehicle, •
no parts are missing, and all screws and nuts are
properly tightened. Inspect for any damaged parts or
loose bolts or fasteners. Review all warning decals and
placement on the vehicle.
Safety Belts: visually inspect and test for safe operation.
•
Tires: check for proper ination as identied on the •
vehicle Certication Label.
Wheels: check for tightness of wheel nuts and axle nuts.
•
Check that axle nuts are secured by cotter pins
Batteries: check electrolyte level in all cells of each
•
battery. If any cell is low, add distilled water as
described in the Battery Care section of this manual. All
wires should be free of corrosion. Batteries should be
fully charged before rst use of vehicle.
Brakes: check hydraulic uid level. If it is low,
•
immediately call a qualied mechanic for service.
Check free-play and operation of brake pedal; ensure
proper brakelight operation; make sure the brake pedal
is operating smoothly. It should not go more than half
way to the oor when depressed. The vehicle should
come to a smooth stop when operating. If excessive
or low pedal pressure, pulling to one side, or unusual
noise is noticed while braking, have the vehicle serviced
immediately.
Parking Brake: make sure the hand operated parking
•
brake is functioning properly. The parking brake should
engage the rear tires when in the up position and
allow the vehicle to roll smoothly when in the released