4.Riding operation
Ready to start
1.
Find a flat field.
2.
Open the product as previously described.
3.
AdjustTtubeheight.
Driving (start assist)
1.
Press the POWER button.
2.
In order to ensure the safety of users, this product is set to assist
start .First, one foot on the E-scooter dock, the other one kick the
ground, keep sliding and sliding, then the E-scooter slowly and gently
speed up at the same time.
3.
The E-scooter start moving forward, at the same time put the foot on
the ground to the E-scooter dock. The greater the Angle of pull
accelerator, the car run faster.
Stopping
Brake handle gently pull back, immediately to cut off the power supply
and speed down, then place one foot on the ground. Remember do not to
brake hard. Because that would abrasion the single side of tyre, lead to
jump, it is not comfortable.
Note: If it is raining, do not use this product, unless control the speed less
than 10 km/h, and shall not brake hard, avoid to slip.
Like most sports, cycling is also there is the risk of injury and damage. By
choosing to ride E-SCOOTER the responsibility and all inherent risk is on
you. It is crucial that you know, understand and act according to safety
rules.
To Next Page
Loading...