Before first use you need to run a cleaning cycle – which should take approximately 10 minutes. You
should clean your unit as part of the setup and again whenever you replace your filter. For hygiene
and safety reasons you should always clean your unit if it has been unused or in storage for longer
than 2 weeks.
Place a container under the dispenser outlet to capture the water used to clean the system (at least 1
litre capacity).
Plug in the unit, the tank empty warning light will illuminate.
With the water hopper in place (but not the filter) fill the hopper with 1 litre of freshly boiled water – –
Wait for the tank empty warning light to go out. The water tank hot light will illuminate.
To Next Page
Loading...
