In addition to the tests described below you can also test the operation of your LINK 530 using the
TomTom Business Solutions Diagnostic Tool with Bluetooth.
Power or Ignition test
Before testing the connection to power and to the ignition make sure you have properly carried
out the installation.
1. Please check all connections to the LINK 530 (wires, fuses etc.).
2. Turn off the ignition.
The green LED must be off and then flash on every 3 seconds.
3. Turn on the ignition.
The green LED must be on and then go off every 3 seconds. If the device is already activated,
the green LED must be on all the time.
If the LED does not perform accordingly, monitor the LEDs for diagnostics .
Mobile network reception test
For this test, you may need to move the vehicle to a location with a clear view of the sky, to make
sure that you have adequate GPS and mobile network reception.
For this test put the LINK 530 in the position where you want to fix it.
1. Turn on the ignition.
2. Monitor the yellow LED. It must be on and go off every 3 seconds.
As soon as the device has established a connection to WEBFLEET the yellow LED stays on all the
time.
If the LED keeps flashing for longer than 10 minutes, monitor the LEDs for diagnostics .
To Next Page
Loading...
Need help?
General
