Getting started2.
3
Getting started
Install your TomTom ONE in your car following the instructions on the
installation poster at the start of this book.
To switch on your TomTom ONE, press and hold the On/Off button for 2
seconds. The first time you switch on your device, it may take a short while to
start.
You have to answer a few questions to set up your device.
Having problems?
In rare cases, your ONE may not start correctly or may stop responding to
your taps.
First, check that the battery is charged properly. To fully charge the battery,
you need to charge it for at least 2 hours.
If this doesn’t work, you can reset your device. To do this, press and hold the
Power button for fifteen seconds. Release the Power button when device
begins to restart.
Charging your TomTom ONE
Before you use your ONE for the first time, it’s a good idea to charge it fully
using the home charger, which takes about 2 hours.
There is no charging light on your ONE. To check the battery status and see
when your ONE is charging, switch on your device and tap the bottom right-
hand corner of the screen in the Driving View. The battery status is shown on
the next page.
Improving reception
If your TomTom ONE takes longer than 5 minutes to find your current
position, make sure that the device is in an open space away from tall objects
such as buildings or trees.
When you connect your TomTom ONE to your computer, you can use
TomTom HOME to download information about GPS satellite positions during
the next 7 days. This helps your ONE to find your position faster.
Important: Some vehicles have heat reflective shielding in the windshield.
This may prevent your ONE from locating your current position.
Take care of your TomTom ONE
Never leave your TomTom ONE or accessories in view when you leave the car
or they may become an easy target for thieves.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
