Need help?Do you have a question about the Tone King Ironman II and is the answer not in the manual?
Provides subtle control of brightness and compression to tailor amp response.
Allows bypassing the attenuator, disabling its function.
Controls the amount of power sent to the speaker, with a wide attenuation range.
Connects the amplifier to the Ironman II using a 1/4" speaker cable.
Provides two jacks for connecting speakers, with impedance matching options.
Connects the provided footswitch to toggle the Solo option on and off.
Connection for the required 12V power supply.
XLR output for sending tone to a mixing board.
Ground lift switch to avoid ground loops when connected to equipment.
Simulates mic placement on speaker cone or edge for tonal variation.
Adjusts output level for matching with audio interfaces or mixing desks.
Allows volume reduction while maintaining full amp output power for tone.
Dual controls match speaker to amplifier, even with different impedance values.
Best practice to dampen guitar strings when adjusting controls.
Provides a proper load for an amplifier with no speakers attached.
Limited 5-Year warranty against defects in material and workmanship.
Any modification not authorized by Tone King in writing will void the warranty.
Steps for returning a defective product for repair or replacement.
Limitation of liability for incidental or consequential damages.
General| Construction | Metal chassis |
|---|---|
| Type | Attenuator |
| Power Handling | 100 watts |
| Inputs | 1 x 1/4" |
| Outputs | 1 x 1/4" |
| Impedance | 4, 8, 16 ohms |
| Controls | Attenuation level switch, line out level control |
| Features | line out with level control |
To Next Page
