To Next PageTo Next Page
Need help?Do you have a question about the Tone King FALCON and is the answer not in the manual?
Describes the two input jacks with different gain levels for connecting guitars.
Explains the interactive nature of volume and tone controls and their impact on the amp's sound.
Details how the Voicing control selects between three distinct tonal characteristics and gain levels.
Provides recommended settings for achieving a blackface Fender-like sound.
Explains settings for a fat clean sound and thick tweed overdrive.
Details settings for overdriven and distorted tones, explaining the role of output tubes for saturation.
Instructions for using a grounded AC cord and ensuring proper connection to the amplifier.
Specifies the type of fuse to be used in the amplifier, a standard 2A slo-blo fuse.
Guides on the correct procedure for powering up and powering down the amplifier.
Details the location and type of the speaker jack and output impedance, and connecting external cabinets.
Explains how the attenuator works, its effect on volume, and factors affecting tone at low volumes.
Recommends specific tube types for different stages and provides notes on brands.
Warns against specific brands of 6V6 tubes due to observed reliability issues like red-plating.
Offers preferences for TAD and JJ brands of 6V6 tubes, describing their tonal characteristics.
Highlights potential failures of certain 12AX7 brands when used in the V2 cathode follower position.
Provides detailed reviews and comparisons of various 12AX7 tube brands and their sonic qualities.
Suggests swapping a 12AU7 in the V1 position for reducing preamp gain.
Provides guidance on correctly orienting and installing tubes into their respective sockets.
Explains that no bias adjustment is needed for replacing output tubes due to cathode biasing.
Discusses current tube manufacturing standards and the unreliability of some new-old-stock tubes.
General
