Electrical connection
07
WARNING:
The brewer must be disconnected from the power source until specified in INITIAL SET-UP.
CAUTION – Improper electrical installation will damage electronic components. Damage caused by incorrect
electrical connections is not covered by warranty.
An electrician must provide electrical service as specified in conformance with all local, state and federal
electrical codes.
Use a voltmeter to check the voltage and color coding of each conductor at the electrical source.
Ensure power switch on rear of brewer is in the off position. Connect brewer to power source and verify
voltage. If plumbing has been hooked up, brewer is ready for Initial Set-Up. If not, disconnect brewer from
power source.
WARNING: Before servicing or opening this device make sure the brewer is disconnected from power by
pulling its plug. The service technician has to see the pulled plug during the whole service operation.
To Next Page
