TONEMAC N18 - Specifications and Warranty; Indicators and Technical Specs; Limited Warranty Information

Limited Warranty
TONEMAC Technology Co., Ltd (“TONEMAC”) warrants this product against defects in material or
workmanship for the periods and as set forth below when purchased directly from TONEMAC or
TONEMAC Retailer. Under this Limited Warranty, TONEMAC will, at its opon, (i) repair the product using
new or refurbished parts or (ii) replace the product with a new or refurbished product. For purposes of this
Limited Warranty, “refurbished” means a product or part that has been returned to its original
specificaons. In the event of a defect, these are your exclusive remedies.
ENG - 7
SPECIFICATIONS & WARRANTY
INDICATOR
SPECIFICATIONS
Indicates
Power on
Power off
Pairing
Connected
Disconnected
Phone call
Low baery
Charing
Full charged
Low latency mode
Music mode
Reset Headphones:
LED
Flash White 3 mes
Flash Red 3 mes
Blinks Red and White
Blinks White
Blinks Red and White
Flash White
Flash Red
Solid Red
Solid White
\
\
Solid White 2 seconds
Voice / Tone
Power on
Power off
Pairing
Connected
Disconnected
Incoming call
Baery low
\
\
Beep beep
Beep
Beep
Model
Bluetooth Version
Bluetooth Profile
Audio Codec Format
Bluetooth Range
Microphones
Playing Time
Charging Time
Driver Size
Frequency Response
Latency
TONEMAC N18
5.2
HSP / HFP / A2DP / AVRCP
SBC / AAC
10 m (33 )
Environment Noise-Cancelling Technology
20 hours in 60% volume
1-hour
10 mm
20 Hz – 20 kHz
80 ms