Tool it PBT 700 - System Test Results Overview; In-Vehicle Test; Warranty Information

22
PBT 700
EN
Original manual
Checktheconnectionsfromthealternatortothebattery.Iftheconnectionislooseorheavilycorroded,
cleanorreplacethecableandretest.Ifthebeltsandconnectionsareingoodworkingcondition,replace
the alternator.
CHARGING SYSTEM NORMAL WHEN TEST WITH ACCESSORY LOADS
The system is showing normal output from the alternator. No problem de-
tected.
ALT. LOAD VOLTS
xx.xx V NORMAL
10.Press«ENTER»whenchargingsystemtestiscompleted.Turnallac-
cessoryloadsandengineoff.Press«ENTER»toreadthesystemtest
results.
TEST OVER. TURN OFF
LOADS & ENGINE
ALT. LOAD VOLTS
xx.xx V NORMAL
RIPPLE VOLTAGE
xx.xx V NORMAL
11. Press “ENTER” to press result or not.
CRANKING VOLTAGE
xx.xx V NORMAL
ALT. IDLE VOLTS
xx.xx V NORMAL
PRINT RESULT?
YES/NO
IN-VEHICLE TEST
This is a combination test of both battery test & system test. Please refer to above testing procedures or follow the
instructions on the display of the tester.
TERMS AND CONDITIONS OF WARRANTY
Thewarrantycoversfaultyworkmanshipfor2yearsfromthedateofpurchase(partsandlabour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported