To Next PageTo Next Page
Need help?Do you have a question about the Tool Shop 241-9846 and is the answer not in the manual?
Always wear eye protection that conforms with CSA requirements or ANSI safety standard Z87.1.
Keep work area clean and well lit; do not operate in explosive atmospheres; keep children and bystanders away.
Match plugs to outlets, avoid body contact with grounded surfaces, protect cord from heat/oil/sharp edges.
Stay alert, use PPE, prevent unintentional starting, don't overreach, dress properly.
Read manual, understand applications, limitations, and potential hazards to reduce risk.
Always wear safety goggles that comply with ANSI safety standard Z87.1.
Always use hearing protection, particularly during extended periods of operation.
Always unplug the tool from the power source before changing the blade and when making any adjustments.
Keep cord clear of work area, use heavy enough gauge cord, ensure it's properly wired and in good condition.
Use outdoor extension cords marked "W-A" or "W" when operating outdoors.
Use a separate circuit with 14 gauge wire protected by a 15 AMP time delayed fuse or circuit breaker.
Study and learn the meaning of symbols for efficient and safer operation.
Warning symbol, wear safety glasses symbol.
Identify key components like blade holder, motor vent, pivoting shoe, and trigger switch.
Unplug tool, rotate locking sleeve, insert blade, release sleeve, check lock.
Rotate blade locking sleeve counter clockwise and remove the blade.
Loosen screws, slide shoe to position, tighten screws, and pull to ensure lock.
Squeeze trigger slightly to turn ON at slow speed; squeeze harder for increased speed.
Use identical replacement parts, avoid solvents on plastic, do not abuse tool, do not modify.
Avoid extended use on fiberglass, wallboard, spackling, plaster due to accelerated wear.
Wear safety goggles, side shields, and dust mask when blowing dust out with an air jet.
All bearings are pre-lubricated for the life of the unit; no further lubrication is required.
List of parts with key number, part number, part name, and quantity.
Always order by part number, not by key number.
Tool carries a 1-year limited warranty from date of purchase for defects.
Excludes expendable parts, commercial use, damage from abuse/misuse.
Call toll-free at 1-866-349-8665 for questions, technical assistance, or repair parts.
General
