Characteristic
Minimum Operating Air Pressure
Maximum Operating Air Pressure
Nail Length Range
Nail Size
Nail Capactity
Air Inlet
Air Consumption
Tool Weight
Value
60 PSI
95 PSI
5/8" -- 1-1/4"
18 & 19 Gauge
100
1/4" NPT
0.38L at 80PSI
2.7 lbs
1
SPECIFICATIONS
SUMMARY
You will need the instruction for the safety warning and precautions, assembly instruction, operating and main-
tains procedures, parts list and diagram. Keep your invoice with this instruction. Write the invoice number on
the inside of the front cover. Keep the instruction and invoice in a safe and dry place for future reference.
READ ALL INSTRUCTIONS BEFORE OPERATING THE TOOL
SAFETY WARNINGS& CAUTIONS
1.KEEP WORKING AREA CLEAN. Cluttered areas invite injuries.
2.DON’T ALLOW CHILDREN KEEP AT THE WORKING AREA. Don’t let them handle the tool.
3.DO NOT OPERATE THIS TOOL IF UNDER THE INFLUENCE OF ALCOHOL OR DRUGS.
Read warning label on prescriptions to determine if your judgment or reflexes are impaired while taking
drugs. If there is any doubt, do not attempt to operate.
4.USE SAFETY GLASSES. Safety glasses should conform to ANSI Z87.1 specifications. Before operating,
wear safety glasses against flying debris from the front and side. Safety glasses should be worn when
loading, operating, unloading or servicing this tool.
5.USE EAR PROTECTION. The working area may be exposed to high noise levels that can lead to
hearing damaged.
6.NEVER USE OXYGEN COMBUSTIBLE GASES, BOTTLED GASES OR HIGH PRESSURE
COMPRESSED GAS AS A POWER SOURCE FOR THIS TOOL. The tool may explode and
cause serious injury.
7.DRESS SAFELY. Protective gloves and nonskid footwear or safety shoes are recommended when
working with and operating this tool. Don’t wear loose clothing or jewelry. They can get caught in moving
parts. Also, wear a protective hair covering to prevent long hair from getting caught in the tool.
8.DO NOT FIRE TO HARD MATERIALS. Do not attempt to shoot toward hard or brittle material
such as concrete, steel or tile.
9.WHEN OPERATING TOOL. keep the proper footing and balance to avoid damaged resulting from
losing balance.
10.CHECK DAMAGED PARTS. Before using tool, carefully check if there is any part damaged.
11.REPLACE PARTS AND ACCESSORIES. Only allow use same replacement parts while servicing.
Approved accessories and replacement parts are available.
12.KEEP ALERT. Watch what you are doing. Use common sense. Do not operate any tool when you are
tired.
To Next Page
Loading...