To Next Page
R
rebeccaproctorAug 12, 2025
Why does my Tool Up Inverter weld poorly?
- CCourtney ZamoraAug 12, 2025
If your Tool Up Inverter welds poorly, it might be due to a polarity error. Make sure to check the polarity (+/-) recommended on the electrode box.
Why does my Tool Up Inverter weld poorly?
If your Tool Up Inverter welds poorly, it might be due to a polarity error. Make sure to check the polarity (+/-) recommended on the electrode box.
What to do if I feel tingling when touching Tool Up Inverter?
If you're feeling a tingling sensation when touching the body of your Tool Up Inverter and suspect it's under voltage, the earth contact might be faulty. Check the plug and the earth of your installation to ensure they are properly connected.
What to do if the green light is on but the Tool Up Inverter does not weld?
If the green indicator is on but your Tool Up Inverter isn't welding, the issue might be with the earth clamp or cable connection. Check these connections to ensure they are properly secured.
What to do if both indicators are on but the Tool Up Inverter does not deliver any current?
If both indicators are on, but your Tool Up Inverter isn't delivering any current, it's possible that the thermal protection has been activated. You'll need to wait for the cooling cycle to complete.
General| Rated Power | 100W |
|---|---|
| Output Power | 100W |
| Input Voltage | 12V DC |
| Output Voltage | 230V AC |
| Frequency | 50 Hz |
| Weight | 0.5 kg |
| Protection | Overload, Short Circuit, Over Temperature, Low Voltage |