EasyManua.ls Logo

ToolPRO ACG18LD - Charging Indicator Guide; Troubleshooting; Battery Fitment Issues; Charging Time Variations

ToolPRO ACG18LD
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Customer Helpline 1300 889 028
ORIGINAL INSTRUCTIONS
7
Charging Procedure
Troubleshooting
1. I CANNOT FIT THE BATTERY INTO THE BATTERY CHARGER.WHY?
Check if the charger and the battery pack are specifically designed for working together.
2. REASONS FOR DIFFERENT CHARGING TIMES.
1) If the battery pack is only partly discharged it may be re-charged in less than 3 hours.
2) If the battery pack and ambient temperature are very cold then recharging may take more
hours.
3) If the battery pack is very hot you must remove your battery pack from the charger and allow
your battery pack to cool first to ambient temperature and then recharging can be started.
NOTE: The charging time can be affected by many reasons which do not indicate defects in
your product. Remove the plug from the socket before carrying out any adjustment, servicing
or maintenance.
CHARGING INDICATOR
This charger is designed to detect some problems that can arise with battery packs.
Indicator lights indicate problems (see table below). If this occurs, insert a new battery
pack to determine if the charger is OK. If the new battery charges correctly, then the
original pack is defective and should be returned to a service center or recycling service
center. If the new battery pack displays the same problem as the original Battery Pack,
have the charger tested at an authorized service center.
Light ON/OFF flash Status
Red on
Charging
Red flash
- - - - - Defective Battery
Green on
Fully Charged
Green flash
- - - - - - Hot/Cold Delay