To Next PageTo Next Page
Need help?Do you have a question about the Toolshop 240-2078 and is the answer not in the manual?
Keep the work area tidy to prevent injuries.
Avoid damp, wet, or poorly lit locations. Keep area well lit.
Avoid body contact with grounded surfaces and touch only plastic grips.
Wear appropriate clothing and protective gear, avoiding loose items and jewelry.
Use clamps or a vise to hold workpieces securely, freeing hands for operation.
Ensure the switch is OFF before plugging in to prevent accidental starting.
Inspect parts for damage, alignment, and tightness before use; repair or replace as needed.
Always use the saw with the guard in place for operator protection.
Connect to a dust collector or use the dust bag provided.
Use a sawblade appropriate for the cutting job and material.
Ensure material is firmly against fence and table to prevent kickback.
Do not start the saw with the blade touching any surface to avoid kickback.
Controls the power to the saw.
Secures the workpiece to the table.
Prevents accidental blade rotation.
Maximum dimensions of material that can be cut.
Laser safety and performance specifications.
Instructions for securely attaching the workpiece using the clamp.
Steps for safely starting and using the miter saw.
Key points to remember before and during operation for safety and performance.
Instructions for setting up and performing various cutting modes.
Check the power cord for damage and have it replaced if necessary.
Inspect and replace motor brushes after approximately 50 hours of use.
Maintain clear vents for cooling and to prevent electrical shorts.
Procedures for adjusting miter and bevel angles to factory specifications.
Steps to align the miter angle correctly.
Steps to align the bevel angle correctly.
Step-by-step instructions for safely replacing the saw blade.
Instruction to consult the schematic for part identification.
Warning against self-repair and contact information for support.
Details of the product's one-year limited warranty.
Contact information for support and service.
Important note about retaining receipts for warranty validity.
General
