Toolshop 241-9869 - User Manual

Questions and Answers

C
Courtney FritzAug 9, 2025
What to do if my Toolshop 241-9869 does not start?
- K
  Kelly GarciaAug 9, 2025
  If your Toolshop Saw does not start when you pull the trigger, there are several possible causes: * There may be no power to the line cord. Check the electrical outlet to ensure it has power. * The switch lock button might not be pushed in. Make sure to press the button while pulling the trigger. * The switch could be defective, requiring replacement. * The carbon brushes may be dirty or worn down. Try cleaning or replacing them.
C
Crystal PierceAug 15, 2025
Why does wood burn or smoke when using my Toolshop Saw?
- B
  Bobby HuffAug 15, 2025
  If wood burns or smokes while using your Toolshop Saw, the saw blade is likely dull. Sharpen or replace the saw blade.
V
vicki72Aug 22, 2025
What to do if my Toolshop Saw slows down while cutting?
- B
  Becky ScottAug 22, 2025
  If your Toolshop Saw slows down while cutting, the carbon brushes might be dirty or worn down. Clean or replace the carbon brushes.
C
Caleb MendozaAug 28, 2025
How to fix a Toolshop Saw blade guard that sticks?
- A
  Angela PerezAug 28, 2025
  If the blade guard on your Toolshop Saw sticks or does not open easily, there may be debris buildup in the blade cover. Remove the saw blade and clean out the blade cover.
M
Mary ChapmanSep 2, 2025
What to do if the blade slips while cutting with my Toolshop Saw?
- A
  Ashley GlennSep 2, 2025
  If the blade slips while cutting with your Toolshop Saw, the hex screw may be loose. Securely tighten the hex screw.