To Next Page
A
aporterAug 7, 2025
Why is my Toolson Pressure Washer pump not producing enough pressure?
- EElizabeth OrozcoAug 7, 2025
There are several reasons why your Toolson Pressure Washer pump might not be producing enough pressure. It could be due to a low-pressure spray tip being installed (replace it with a high-pressure one), a blocked water inlet (clear it), an inadequate water supply (provide adequate water flow), a kinked or leaking inlet hose (straighten the hose or patch the leak), a clogged inlet hose strainer (check and clean it), a water supply that's too hot (use cooler water), a blocked or leaking high-pressure hose (clear any blockages), a leaking gun (replace it), or an obstructed spray tip (clean it). If none of these solve the issue, the pump may be faulty, and you should contact an authorized service facility.
General