A. ASSEMBLE GUIDE BAR (10) THROUGH THE HOLE FROM THE TOP SIDE OF RIGHT
UPRIGHT FRAME (5), THEN SLIDE RIGHT BARBELL SLIDING SEAT (18) ONTO GUIDE
BAR (10), NEXT RUBBER CUSHION (31) , Φ50MM WASHER (41) , SPRING (25) ,AGAIN
Φ50MM WASHER (41) , RUBBER CUSHION (31), FINALLY RIGHT SLIDING TUBE （14）,
AFTER HAVE ALL THESE PARTS ON AS SHOW , INSERT THE END OF GUIDE BAR (10)
INTO THE HOLE AT THE BOTTOM OF RIGHT UPRIGHT FRAME (5) . USING 1PCS
M10X16 HEX BOLT (36) AND 1PCS M10 WASHER (40) TO TIGHT THE GUIDE BAR (10)
FROM THE BOTTOM , AND THEN USING 1PCS M10X16 HEX BOLT (36) , 1PCS M10
WASHER (40) AND 1PCS Φ38MM WASHER (42)TO TIGHT THE GUIDE BAR (10) FROM
THE TOP SIDE AS SHOW
B. ASSEMBLE GUIDE BAR (10) AT THE LEFT SIDE AS THE SAME WAY
36
40
42
36
40
42
10
18
17
13
14
25
31
31
41
41
40
36
40
36
4
5
10
To Next Page
